Oil sludge is the thing left by long-term use of mineral oil, especially the recommended engine with oil additives. It is simpler to accumulate oil sludge. If the oil sludge is too thick and you don't want to dismantle the recommended engine, you can dismantle the valve cover and oil pan, soak it in diesel oil, and then brush it with gasoline, especially the oil pump. You must dismantle it and clean it carefully, but dismantle the cover and oil bottom once The shell has to be replaced with a mat, which can cost hundreds of dollars.
Take the high-pressure water gun, and then put on the engine oil. The unit has a car washer. There seems to be a special spray for cleaning chain grease. Diesel is the best thing for other things, which are either expensive or have negative effects (such as gasoline). But the problem is that there is basically no lack of oil on the surface of the chain. Just add some clean oil at will. Don't trust any chain oil. If there is oil, it will hang ash.
Generally, there are two simple cleaning methods for the recommended machine. One is to add the cleaning oil added in the engine oil, the other is to connect the machine to the recommended machine and wash it with a cleaning agent circularly. If you want to thoroughly clean the sludge in the mixer, you must collapse the mixer and use the ultrasonic machine to clean it thoroughly. If there is no major problem with your mixer, you are not recommended to dismantle the mixer for cleaning. If you suggest that the sludge in the machine has too much carbon and the oil consumption noise increases obviously, then any cleaning can't solve the problem, so you can only dismantle, wash and maintain it. If you say goodbye with low labor cost and wait for it to break down, disassemble and wash it earlier.
Then it introduces the cause of formation of carbon sludge and its influence on the proposed machine
1. Adopt "high-end and low-speed" bad driving habits.
2. Long term idle operation and low-speed travel.
3. Gasoline with purity and quality not up to the requirements is used.
First, use a rag to roughly clean up, then put a little gasoline out and use the brush to finish the rest of the poor cleaning down. After brushing, use the replaced oil or the rest of the base in the oil bottle to finish the brush and then apply another layer of oil. Generally, they don't go to clean up. Mostly after changing the oil and staying idle in a friend's repair shop. I took it down and washed my hair with detergent and water first, then washed it with diesel oil and then put on the engine oil. Then I wiped the remaining engine oil with a cloth and put it on the car.
Usually use the eliminated children's toothbrush to touch the contact parts of the front and rear teeth of the engine oil brush as little and even as possible, so as to less dust. Remove the chain, put the chain into a large coke bottle, and pour in a proper amount of cleaning agent (five pieces of alcohol for one bottle, which is available in the drugstore and can be washed more than three times). Cover it, shake it several times, take it out and put it on.
This article comes from: Zhongke Jufeng mixer more content please click: http://www.pingqxw.com we will provide a satisfactory service for your questions, welcome your call!